Following is the procedure for setup and operation.

• Mount the work to be cut inside the vise
  
• Lower the frame so that the blade is about 1/8" from touching the material
  
• Using a scale, measure from the outer edge of the blade to the end of the work-piece
  
• Tighten the vise NOTE: movable jaw pivot bolt must be hand tight only. If this bolt is over tighten, the vise will not securely fasten
  
• Recheck measurement
  
• If multiple parts of the same size are to be cut, set the work stop to the desired length. NOTE: to prevent damage to the blade, a gap must be provided between the stop and the workpiece.
  
• Release the frame so that it rises to the start position. This will prevent the blade from contacting the material on the first stroke, which could damage the blade
  
• Select the proper speed and feed
  
• Turn machine on
  
• Engage power feed lever
  
• With a new blade, never start on a previously started location as this will cause the new blade to bind and break
  
• Verify that coolant is directed to area of blade contact to ensure cooling and chip wash